Step 1 dBfoam, a compression-resistant foam is laid onto the structural sub-deck. A unique edge isolation system incorporating a combination of edgeboard shuttering and specially developed Screedflo edgestrip is then applied around all the wall surfaces.	Step 2 Screedflo dBoard, a high density, moisture proof fibreboard is then laid on top of the dBfoam.
Step 3 A polythene tanking membrane is laid on top of the dBoard. If specified, under floor heating is laid on top of this membrane.	Step 4 Precision checks are made ensuring a quality end result.
Step 5 National coverage is achieved using Screedflo’s mobile batching vehicle.	Step 6 The Screedflo Anhydrite screed is pumped into the development using a sophisticated computer controlled batching system.
Step 7 A rapid-drying 40mm Screedflo Anhydrite screed is laid onto the polythene membrane and underflooor heating.	Step 8 The finished product!